HUAWEI Y6 Prime 2019 display light solution/MRD-LX1FHUAWEI Y6 PRIME NOT DISPLAY DUT TO LIGHT ISSUE SOLUTION.
One of the most common reasons for a HUAWEI Y6 PRIME 2019 to shut down unexpectedly is a faulty battery or charging issues. It’s important to start by checking the health of the battery and the quality of the charging. Steps: 1. Ensure that your HUAWEI Y6 PRIME 2019’s battery is in good condition and not swollen. 2.
Turn off and then on the NFC switch by swiping down on the home screen of your phone. The Huawei Y6P can connect to Wi-Fi 802.11 a/b, NFC, headphones, FM radio, 3G, and 4G, as well as having active 4G on both SIM cards. There are also sensors such as the ambient light sensor, the compass/magnetometer, proximity sensor, and the fingerprint
The solution below shows the Huawei Y6 Prime (2019) Backlight Ways LCD and display jumper or components that hold and control for the LCD screen display backlight to glow. If one of these components may become faulty due to wet or water damaged it will result in LCD’s backlight failure. Huawei Y5 2019: R719: Huawei Y6: R949: just two ways, and you shouldn’t need to replace your device over something like a damaged jack or faulty charging port Try to reboot your HUAWEI Y6 2019 phone. Remove the SIM card (s) and insert it/them again. If the problem persists, purchase a new SIM card. Check if there is any damage to the SIM card or SIM card holder. Go to Network Settings and check if the specified SIM is activated. Ifo1XHv.